The Wizard of Creation new series of points

On a step 1 it is possible to select the data.

• For parameters X, Y, Z select columns.
• Assign with what line to begin to read the data.
• To do it, scroll the table. Up to 100 lines can be displayed.

On a step 2 data are read. Assign the X, Y  clip region and scale factors.

• Select X, Y intervals 'min' and 'max' in physical units of measurements. Only points inside clipped intervals will be added to points series.
• Assign multiplier. Each data point will be multiplied by the scale factor. Use it to normalize values with different physical units of measurements.
• Use button <Limits> to set the data read X and Y intervals to clipping region.
• Use button <Axis> to set the current plot intervals to clipping region.
• Select to add all points read to new series. Or only points inside clipped intervals will be added.

On a step 3 set new ranges of  X, Y in plot. 

• Set the axis name and physical units of measurement of parameter.
• Select new ranges. Then you click <Next> button, the scales will be recalculated.
• Use button <Current> to set the previous plot interval.
• Use button <Clipped> to set the clipping region to new plot interval.

On a step 4 data are prepared, a new series of points will be built.

• Set a title of a series.
• Assign a color, marker, radius (X) and aspect ratio (Y/X) for new points series.
• Use button <Add Series> to create new series of points.

Trick: Repeat steps (1-2-3-4), on step 1 select new columns, and use button <Add Series> to add next series of points from one table.

See example.

á